Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

naah
  • Locked
  • Question
Least square circle (GG) 2
Replies
17
Views
2K
pmarc
pmarc
3DModelProf
  • Locked
  • Question
3D Modeling and Design Standards for Diecast Manufacturing 1
Replies
6
Views
343
CWB1
CWB1
SeasonLee
  • Locked
  • Question
Question on ISO hole pattern 3
Replies
5
Views
686
SeasonLee
SeasonLee
dthom0425
  • Locked
  • Question
Partial Datum - Area
Replies
3
Views
480
3DDave
3DDave
Burunduk
  • Locked
  • Question
Did circularity change?
Replies
5
Views
267
Burunduk
Burunduk
rollingcloud
  • Locked
  • Question
Aligning holes on center of spline teeth for a spline sleeve
Replies
3
Views
385
Burunduk
Burunduk
drawoh
  • Locked
  • Question
Videos and Other Training 1
Replies
13
Views
315
3DDave
3DDave
3DDave
  • Locked
  • Question
AME, UAME, and Index - 2018 1
Replies
1
Views
2K
R. Dean Odell
R. Dean Odell
sendithard
  • Locked
  • Question
Does a spherical diamter position require rotation dof to be locked down
2
Replies
35
Views
423
Burunduk
Burunduk
2020Learner
  • Locked
  • Question
OZ offest tolerance ZOne. ISO GPS 3
Replies
16
Views
2K
pmarc
pmarc
Bogdan.
  • Locked
  • Question
Macro for drawing view
Replies
1
Views
83
drawoh
drawoh
J Taylor
  • Locked
  • Question
True Position of a hole to a face & Profile Question
Replies
2
Views
224
Burunduk
Burunduk
3DDave
  • Locked
  • Question
CMM used to measure free-state component to meet restrained state requirement
Replies
0
Views
267
3DDave
3DDave
freerangequark
  • Locked
  • Question
Composite tolerance on hole pattern of different sized holes.
Replies
6
Views
759
freerangequark
freerangequark
Goppinath
  • Locked
  • Question
GD&T call out for cam shaft
Replies
1
Views
182
Burunduk
Burunduk
ortabe
  • Locked
  • Question
ISO 1101:2012 - Tolerance zone orientation
Replies
13
Views
696
ortabe
ortabe
Burunduk
  • Locked
  • Question
Directly toleranced radius with a "located" center, ASME Y14.5-2018 4
2
Replies
29
Views
1K
Burunduk
Burunduk
norlo
  • Locked
  • Question
Installation Drawing Information in Multiple Installation Drawings
Replies
2
Views
218
3DDave
3DDave
SeasonLee
  • Locked
  • Question
How many DOF does datum feature A constrain? 1
Replies
10
Views
1K
3DDave
3DDave
GravyBagel
  • Locked
  • Question
Symmetric Parts and Inspection of Features
Replies
5
Views
248
Burunduk
Burunduk
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top Bottom