Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

ModulusCT
  • Locked
  • Question Question
Dimensions apply after plating...
Replies
18
Views
957
drawoh
drawoh
grunt58
  • Locked
  • Question Question
angle hole
2
Replies
29
Views
723
PeterStock
PeterStock
metalonis
  • Locked
  • Question Question
KAPL Document
Replies
3
Views
171
CheckerRon
CheckerRon
macduff
  • Locked
  • Question Question
Company Title Block Signatures
Replies
17
Views
579
fcsuper
fcsuper
genes
  • Locked
  • Question Question
All tolerances are non-accumulative
2
Replies
20
Views
1K
fcsuper
fcsuper
biglaw22
  • Locked
  • Question Question
Countersinks?
Replies
17
Views
2K
KENAT
KENAT
Serrand
  • Locked
  • Question Question
Mechanical Engineer lost on civil rebar drawings
Replies
5
Views
267
Serrand
Serrand
vctech
  • Locked
  • Question Question
General Tolerances
Replies
19
Views
1K
KENAT
KENAT
ModulusCT
  • Locked
  • Question Question
Couple Flatness Questions
Replies
15
Views
225
powerhound
powerhound
bbook1
  • Locked
  • Question Question
3D Modeling Best Practice
2
Replies
32
Views
1K
dmech
dmech
dmech
  • Locked
  • Question Question
Mixing Ordinate & "Standard Dimensions
Replies
5
Views
935
dmech
dmech
Amorak
  • Locked
  • Question Question
True position. Multi diameters within a tube.
Replies
2
Views
96
KENAT
KENAT
cjohnso0
  • Locked
  • Question Question
Composite True Position Interpretation
Replies
14
Views
525
KENAT
KENAT
RunningFree
  • Locked
  • Question Question
Near Flat Conical Surface as primary Datum
Replies
5
Views
137
drawoh
drawoh
EidenC
  • Locked
  • Question Question
Multiple Angle Dimensions (Equally Spaced)
2
Replies
29
Views
722
ctopher
ctopher
ME7
  • Locked
  • Question Question
Tolerance Analysis RSS and GDT
Replies
1
Views
110
ctopher
ctopher
ingallspw
  • Locked
  • Question Question
Drafting the center of gravity
Replies
7
Views
557
ctopher
ctopher
ryandias
  • Locked
  • Question Question
Question, What is the difference between A & B?
2
Replies
24
Views
348
PaulJackson
PaulJackson
Checker56
  • Locked
  • Question Question
company standards
Replies
6
Views
155
looslib
looslib
pmarc
  • Locked
  • Question Question
Composite Positional Tolerancing?
2
Replies
25
Views
311
MechNorth
MechNorth
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top