Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

JasonNicholson
  • Locked
  • Question
Multiple of Same View on Same Sheet for Clarity
Replies
12
Views
340
drawoh
drawoh
Spurs
  • Locked
  • Question
GD&T Callout for true postion not based on diameter tolerance zone
Replies
6
Views
177
Spurs
Spurs
Superslinky
  • Locked
  • Question
Another Rev Question... and Notes (general vs. flag vs. revision) 1
Replies
19
Views
700
SeasonLee
SeasonLee
dimensioningman
  • Locked
  • Helpful tip
CAD DATA EXCHANGE
Replies
11
Views
113
ewh
ewh
gregfox
  • Locked
  • Question
GD&T MMC versus Tolerance
Replies
15
Views
480
gregfox
gregfox
Sybot1978
  • Locked
  • Question
Total Runout tolerance Vs Position Tolerance 2
Replies
7
Views
562
PeterStock
PeterStock
TeejT
  • Locked
  • Question
"LT" field in revision table
Replies
16
Views
168
PeterStock
PeterStock
FlyingGrimReaper
  • Locked
  • Question
Proper Drafting Standards Documentation for startup companies 2
Replies
18
Views
210
fcsuper
fcsuper
finisher
  • Locked
  • Question
Centrality of bore intersection - how specify using GD&T? 1
Replies
1
Views
94
Belanger
Belanger
evolDiesel
  • Locked
  • Question
Rev A symbol on a Rev A print ?? 5
Replies
18
Views
553
KENAT
KENAT
uptick
  • Locked
  • Question
True position callout 3
Replies
13
Views
367
fsincox
fsincox
SteveMartin
  • Locked
  • Question
How to tolerance non-orthogonal holes
Replies
8
Views
247
SeasonLee
SeasonLee
BKM2
  • Locked
  • Question
Coaxial vs concentricity 2
Replies
12
Views
725
BKM2
BKM2
gageblockhead
  • Locked
  • Question
Alignment gage for seperated cylinder diameters.
Replies
3
Views
113
dingy2
dingy2
kbtonk
  • Locked
  • Question
stacked dimensioning standard 1
Replies
7
Views
340
dgallup
dgallup
mack52
  • Locked
  • Question
linear dimensions on geometricly toleranced print 3
2
Replies
38
Views
751
axym
axym
FlyingGrimReaper
  • Locked
  • Question
Repetitive Features and Spacing of Holes
Replies
4
Views
537
KENAT
KENAT
swisscheese
  • Locked
  • Question
Minimally dimensioned CAD drawings GD&T 3
3 4 5
Replies
97
Views
2K
swisscheese
swisscheese
BodyBagger
  • Locked
  • Question
Determining Acceptable True Position for the FCF
Replies
7
Views
245
KENAT
KENAT
johnchrc
  • Locked
  • Question
Pitch Diamter Rule - How is it controlled? 1
Replies
6
Views
162
johnchrc
johnchrc
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top Bottom