Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

cfordyce05
  • Locked
  • Question Question
Bonus Tolerance Question, MMC on a Datum
2
Replies
25
Views
790
Belanger
Belanger
Dave K
  • Locked
  • Question Question
Blind hole for studs, standard?
Replies
4
Views
321
Dave K
Dave K
dodge78
  • Locked
  • Question Question
Profile callout
2
Replies
26
Views
518
fsincox
fsincox
Madhu454
  • Locked
  • News News
Thank you all
Replies
13
Views
186
fsincox
fsincox
Madhu454
  • Locked
  • Question Question
Usage of Datums in Profile of a Line.
2 3 4
Replies
60
Views
1K
fsincox
fsincox
RedNova1
  • Locked
  • Question Question
Can i use a point as my datum?
2
Replies
21
Views
761
fsincox
fsincox
Chaldaean
  • Locked
  • Question Question
Help Interpreting Drawing
2
Replies
24
Views
408
fsincox
fsincox
Madhu454
  • Locked
  • Question Question
Runout using only on a partial radial portion
Replies
11
Views
404
dingy2
dingy2
clamschlauder
  • Locked
  • Question Question
Axis Straightness vs Surface Straightness
Replies
16
Views
843
clamschlauder
clamschlauder
Runz
  • Locked
  • Question Question
Non GD&T dimensioned features & assumed tolerances
2 3
Replies
40
Views
1K
fcsuper
fcsuper
ptruitt
  • Locked
  • Question Question
Profile of a Line per Y14.5-Next
Replies
14
Views
392
pmarc
pmarc
fsincox
  • Locked
  • Question Question
Does the ISO allow for Radial Datums Features?
Replies
6
Views
169
fsincox
fsincox
ctopher
  • Locked
  • Question Question
SI units tol
2 3
Replies
43
Views
653
pmarc
pmarc
greenimi
  • Locked
  • Question Question
Design intent versus proposed drawing update.
Replies
11
Views
278
TheTick
TheTick
Bouing
  • Locked
  • Question Question
Reference dimension, Assembly drawing and Y14.5 2009
Replies
10
Views
847
ptruitt
ptruitt
powerhound
  • Locked
  • Article Article
Please review and provide feedback
Replies
18
Views
444
TheTick
TheTick
SVillagrasa
  • Locked
  • Question Question
Using multiple arrows for the same tolerance
Replies
8
Views
219
SVillagrasa
SVillagrasa
Belanger
  • Locked
  • Question Question
Checking Runout on a CMM
Replies
4
Views
1K
PaulJackson
PaulJackson
farmENGR
  • Locked
  • Question Question
Locating- GDT
Replies
7
Views
207
farmENGR
farmENGR
lessfull
  • Locked
  • Question Question
Parallelism question
Replies
2
Views
264
lessfull
lessfull
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top