Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

dlloydks
  • Locked
  • Question Question
ISO GTOL (GPS) Stds
2
Replies
30
Views
839
fsincox
fsincox
duk748
  • Locked
  • Question Question
spotface diameter for m42 nut
Replies
2
Views
202
duk748
duk748
Belanger
  • Locked
  • Question Question
Total Runout on a Cone
2
Replies
36
Views
2K
Belanger
Belanger
duk748
  • Locked
  • Question Question
process of reducing engineering errors & ecn'n
2
Replies
23
Views
435
KENAT
KENAT
posture
  • Locked
  • Question Question
Which standard for steel fabrication?
Replies
5
Views
443
KENAT
KENAT
prdave00
  • Locked
  • Question Question
Creating a reference frame - options
Replies
2
Views
137
fsincox
fsincox
ModulusCT
  • Locked
  • Question Question
Correct Application of Reference Dimension?
Replies
11
Views
763
ModulusCT
ModulusCT
CheckerHater
  • Locked
  • Question Question
The Invocation Principle - Good or Bad?
Replies
11
Views
389
fcsuper
fcsuper
Fortelas
  • Locked
  • Question Question
Question on total runout and circular runout in Y14.5-1994 standard
Replies
7
Views
173
MechNorth
MechNorth
SpaciouS
  • Locked
  • Question Question
BOUNDARY for noncircular features
Replies
14
Views
1K
Belanger
Belanger
ModulusCT
  • Locked
  • Question Question
Hole Notes (ASME Y14.5M-1994)
2 3
Replies
40
Views
3K
KENAT
KENAT
axym
  • Locked
  • Question Question
Y14.5.1 Standard - Mathematical Definitions
Replies
11
Views
323
MechNorth
MechNorth
greenimi
  • Locked
  • Question Question
Datum shift when datum is a thread, quick question
Replies
19
Views
363
MechNorth
MechNorth
ptruitt
  • Locked
  • Question Question
"inspection software doesn't follow the standard"
Replies
4
Views
130
axym
axym
ArubaBob
  • Locked
  • Question Question
Datum selection for inspection?
Replies
5
Views
153
CheckerHater
CheckerHater
maheP
  • Locked
  • Question Question
GD&T for Dummies
Replies
14
Views
530
SeasonLee
SeasonLee
danhunter
  • Locked
  • Question Question
Drawing within a drawing
Replies
5
Views
191
ModulusCT
ModulusCT
drstrole
  • Locked
  • Question Question
Flatness of a derived median plane per unit length.
Replies
10
Views
354
fsincox
fsincox
Belanger
  • Locked
  • Question Question
Minor errors in Y14.5?
2
Replies
29
Views
791
axym
axym
macduff
  • Locked
  • Question Question
Passivate Drawing Note Advice
Replies
2
Views
164
ctopher
ctopher
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top