Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

lonsgsp
  • Locked
  • Question Question
Repetitive feature dimension (total)
Replies
6
Views
341
KENAT
KENAT
BEAEROHEAD
  • Locked
  • Question Question
Auto populate the callout columb
Replies
1
Views
93
3DDave
3DDave
Dobe
  • Locked
  • Question Question
Geo Tolerancing of Steel Castings
Replies
4
Views
192
KENAT
KENAT
SteelAndSteel
  • Locked
  • Question Question
Question about circular runout
2
Replies
24
Views
783
CheckerHater
CheckerHater
ModulusCT
  • Locked
  • Question Question
TP FCF on a Hole Note Applies to Which Feature? Thru Hole or C'Bore?
Replies
9
Views
295
3DDave
3DDave
ModulusCT
  • Locked
  • Question Question
Need some help - New job & I'm not producing drawings that are 'good enough'.
2
Replies
37
Views
643
ModulusCT
ModulusCT
DetroitDesigner
  • Locked
  • Question Question
Profile of a Curve on a Centerline
Replies
3
Views
219
DetroitDesigner
DetroitDesigner
TommD
  • Locked
  • Question Question
Rounding dimensions for part inspection
2
Replies
33
Views
2K
CheckerHater
CheckerHater
SBRIRONMAN
  • Locked
  • Question Question
? on assemblies
Replies
1
Views
100
cowski
cowski
ronj100
  • Locked
  • Question Question
Do I even need datums for this profile?
Replies
9
Views
198
ronj100
ronj100
201181
  • Locked
  • Question Question
Showing part families on assembly drawings
Replies
1
Views
98
dgallup
dgallup
ray98
  • Locked
  • Question Question
Drawing Views
Replies
18
Views
1K
randy64
randy64
steveapathy
  • Locked
  • Question Question
GD&T On Drafted Plastic Parts
Replies
8
Views
764
TommD
TommD
greenimi
  • Locked
  • Question Question
Interesting questions on datum feature simulators on linkedin
Replies
10
Views
393
fsincox
fsincox
learningchecker
  • Locked
  • Question Question
Phantom Datum on a Product Design Drawing
Replies
13
Views
202
learningchecker
learningchecker
3DDave
  • Locked
  • Question Question
Determining tolerance limits
2
Replies
31
Views
839
3DDave
3DDave
waqasmalik
  • Locked
  • Question Question
Identification of primary datum features
Replies
3
Views
163
gabimo
gabimo
engiNERD77
  • Locked
  • Question Question
ansi 4"-150# flange
Replies
2
Views
150
engiNERD77
engiNERD77
illini8181
  • Locked
  • Question Question
GD&T Reference Book
Replies
4
Views
239
3DDave
3DDave
SeasonLee
  • Locked
  • Question Question
Means of "Min Draft"
Replies
4
Views
274
pmarc
pmarc
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top