Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

ingallspw
  • Locked
  • Question
Is there a standard that requires a parts list (or BOM) in a certain section/placemnt of the print?
Replies
5
Views
174
ingallspw
ingallspw
MrGearhead
  • Locked
  • Question
Perpendicularity to make sure a threaded part sits flat to a sealing surface
Replies
1
Views
88
Heckler
Heckler
bean777
  • Locked
  • Question
Specifying position and orientation of a thin part on a PCB
Replies
2
Views
162
3DDave
3DDave
cbrf23
  • Locked
  • Question
Define mismatch allowance on a cylindrical ID
Replies
16
Views
653
CheckerHater
CheckerHater
loughnane
  • Locked
  • Question
dimension ID's on drawing 1
Replies
15
Views
445
cbrf23
cbrf23
TED7
  • Locked
  • Question
ISO 5459 and ISO 1101
Replies
2
Views
317
TED7
TED7
lonsgsp
  • Locked
  • Question
Repetitive feature dimension (total)
Replies
6
Views
275
KENAT
KENAT
BEAEROHEAD
  • Locked
  • Question
Auto populate the callout columb
Replies
1
Views
81
3DDave
3DDave
Dobe
  • Locked
  • Question
Geo Tolerancing of Steel Castings
Replies
4
Views
118
KENAT
KENAT
SteelAndSteel
  • Locked
  • Question
Question about circular runout
2
Replies
24
Views
553
CheckerHater
CheckerHater
ModulusCT
  • Locked
  • Question
TP FCF on a Hole Note Applies to Which Feature? Thru Hole or C'Bore?
Replies
9
Views
174
3DDave
3DDave
ModulusCT
  • Locked
  • Question
Need some help - New job & I'm not producing drawings that are 'good enough'. 4
2
Replies
37
Views
408
ModulusCT
ModulusCT
DetroitDesigner
  • Locked
  • Question
Profile of a Curve on a Centerline
Replies
3
Views
167
DetroitDesigner
DetroitDesigner
TommD
  • Locked
  • Question
Rounding dimensions for part inspection 9
2
Replies
33
Views
2K
CheckerHater
CheckerHater
SBRIRONMAN
  • Locked
  • Question
? on assemblies
Replies
1
Views
88
cowski
cowski
ronj100
  • Locked
  • Question
Do I even need datums for this profile?
Replies
9
Views
173
ronj100
ronj100
201181
  • Locked
  • Question
Showing part families on assembly drawings
Replies
1
Views
82
dgallup
dgallup
ray98
  • Locked
  • Question
Drawing Views 2
Replies
18
Views
991
randy64
randy64
steveapathy
  • Locked
  • Question
GD&T On Drafted Plastic Parts
Replies
8
Views
627
TommD
TommD
greenimi
  • Locked
  • Question
Interesting questions on datum feature simulators on linkedin 2
Replies
10
Views
302
fsincox
fsincox
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top Bottom