Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME Section VIII Division 1 and Division 2

Status
Not open for further replies.

manian

Industrial
Joined
Sep 9, 1999
Messages
42
Location
AE
ASME Section VIII Division 1 Appendix 2 gives the design
procedure for flanges using allowable stresses as per
Table 3 for bolting materials in Section II part D. Similarly Section VIII Division 2 Appendix 4 cross refers
to Appendix 3 for Flange Design but with design stress
intensity for bolting materials as per Table 4 of Section II
Part D. Could some one substantiate the circumstances where
the above two different approaches are applied and the
reason behind it.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top