Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

PD 5500 - Bevel Degree for Self Reinforced nozzle

Status
Not open for further replies.

hockchong

Mechanical
Joined
Dec 9, 2002
Messages
29
Hi everyone,
For ASME Div. 1, normally we will apply 30° for bevel on forge nozzle and 45° for Div. 2.

How about PD 5500? 30° or 45°?

Thanks.

Regards,
Lee
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top