Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mesh Transition Shell

Status
Not open for further replies.
jackyyau

jackyyau

Civil/Environmental
Joined
May 13, 2002
Messages
38
Location
HK
Suppose a floor meshed into 9 by 9 shells each is 1m x 1m and a wall meshed into 6 by 6 shells each is 1.5m x 1.5m.

In SAP2000 Version 8.2, how can the floor/wall interface shells be quickly meshed into a transition zone?

I tried "mesh using seleted joints and on edges" but it did work! SAP2000 Ver 8.2 is not smart enough to use triangular sheels to do the transition zone.

Any quick method?
 
Status
Not open for further replies.

Similar threads

giofed
  • Locked
  • Question Question
SAP 2000 Shell twisting moment
Replies
1
Views
1K
JoshPlumSE
JoshPlumSE
jmramos
  • Locked
  • Question Question
modeling shell elements in SAP2000
Replies
1
Views
801
271828
271828
Bezujov
  • Locked
  • Question Question
Nonlinear analysis shell
Replies
1
Views
1K
NRam
NRam
Huy Le
  • Locked
  • Question Question
Display shell stresses-Von-Mises stress
Replies
3
Views
1K
driftLimiter
driftLimiter
jmramos
  • Locked
  • Question Question
Problem with writing shells in ETABS
Replies
0
Views
2K
jmramos
jmramos

Part and Inventory Search

Sponsor

Back
Top