Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Searching for injection mouldable ceramic feedstock
- Thread starter ZTA
- Start date
Two suppliers of ceramic injection molding feedstock are the following:
Ceramicguy
Materials
Honeywell, the old Allied Signal company in Morristown New Jersey USA used to sell an aqueous binder system suitable for ceramics and metals used in injection molding-primarily low pressure, high solids molding. I think their website is
At one point they were licensing the metal injection molding technology. I don't know the current status of the binder system.
At one point they were licensing the metal injection molding technology. I don't know the current status of the binder system.
The Allied Signal technology is licienced to Latitude Manufacturing. I don't think they are doing a Ceramic at this point. BASF makes a catalytic debind feedstock for Alumina and Zirconia. For details check out
- Status
Similar threads
- Locked
- Question
- Question
- Locked
- Question
