Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
What is the standard for paint defect tolerance?
- Thread starter Charon99
- Start date
IMO, this is an Inspection Guidelines for the measurements in the Japanese Spec, including:
Table (A): Diameter- Black dot for OD, white for ID, and marked with letters, i.e. A,B,C...
Table (B): Area
Table (C): Line Width- External dimension for Black line, Internal Dimension for White line
Table (A): Diameter- Black dot for OD, white for ID, and marked with letters, i.e. A,B,C...
Table (B): Area
Table (C): Line Width- External dimension for Black line, Internal Dimension for White line
- Thread starter
- #3
I need to reference this in a specification I'm creating, but I don't know how to without recreating it and incorporating my recreation. Ideally I'd like to reference the specific standard and specify the scope and level required.
p.s. English or Chinese (not Japanese).
p.s. English or Chinese (not Japanese).
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question
