Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME B31.3, ASME SEC IX IMPACT TESTIING.

Status
Not open for further replies.
QC95

QC95

Mechanical
Oct 28, 2022
1
I am reviewing a WPS and there was a comment made on the T limits on fillet welds when impact testing is req.
Question is if there is a max base metal thickness limit on fillet welds qualified through groove PQR?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

FAHADRANA
  • Locked
  • Question
WQT for Combination of Welders as per ASME Sec IX
Replies
3
Views
4K
DekDee
DekDee
jayinwww
  • Question
Calculating Stress Ratio ASME B31.3 Figure 323.2.2A Note 6
Replies
0
Views
212
jayinwww
jayinwww
MhmdNfri
  • Question
ASME Sec. I / NDT / PW-11 / Table PW-11
Replies
2
Views
150
goutam_freelance
goutam_freelance
Motivated Apprentice
  • Locked
  • Question
Diameter in ASME IX
Replies
2
Views
874
Motivated Apprentice
Motivated Apprentice
Drilling Integrity Super.
Formula for Calculating Basic Allowable Stresses in ASME B31.3
Replies
2
Views
4K
Geoff13
Geoff13

Part and Inventory Search

Sponsor

Back
Top Bottom