Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

IR LED solidworks thermal simulation unexpected extreme low temperature problem

Status
Not open for further replies.

seraph3333

Mechanical
Joined
Jun 30, 2010
Messages
7
Location
US
Hi,
In solidworks thermal simulation, I built up this following model:
Have 70 piece of IR LED arranged on a round 8-inch PCB, each LED is 11W.
Set the LED emissivity as 0.9, the material to be heater emissivity as 0.6
All body initial temperature as room temperature.
All face convection as 50W/m2.K
The thing is after steady state study, the thermal result shows extreme low temperature, such as -850C.
Capture_idfidt.jpg

Not sure where did I set wrong, please help.

Thanks,
Hao
 
Such problems are often caused by too coarse mesh, try refining it significantly. Also, make sure that the initial temperature is properly applied to the whole model.
 
Thank, FEA way.
But mesh are very fine down to 1mm.
And the initial temperature is applied to all bodies.
Any other place could I did wrong?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top