Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Poisson's ratio of 42CrMoS4

Status
Not open for further replies.
chen2003

chen2003

Materials
Joined
Mar 14, 2003
Messages
2
Location
AT
Hi,

I want to check the Poisson's ratio of 42CrMoS4. But I can not find it. Who can tell me where I can get it? Thank you in advance.

Best regards

chen2003
 
Sort by date Sort by votes
Poisson's ratio is generally accepted to be 0.29 for steel.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

yurachv
  • Question Question
results of tests as per SA-480
Replies
3
Views
5K
SWComposites
SWComposites
Muhammad Ijaz
  • Locked
  • Question Question
Availability of 3mm thick As rolled ASTM A516 70 plate normalized and impact tested
Replies
0
Views
1K
Muhammad Ijaz
Muhammad Ijaz
Muza33
  • Locked
  • Question Question
heating rate applicable for normalisation of Dish end for pressure vessel
Replies
0
Views
754
Muza33
Muza33
Muhammad Ijaz
  • Locked
  • Question Question
Hydrostatic test of tubes
Replies
1
Views
875
EdStainless
EdStainless
ValvEng05
  • Locked
  • Question Question
Allowable stress value of A453 660 D Studs
Replies
0
Views
877
ValvEng05
ValvEng05

Part and Inventory Search

Sponsor

Back
Top