Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Please explain, As per ASM sec.VII

Status
Not open for further replies.
RVinothkumar

RVinothkumar

Mechanical
Apr 16, 2021
31
Please explain,
As per ASM sec.VIII Dev.1 if two indication found in RT Film of weld joint what is the acceptance criteria for that
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Ok sir, Thanks for your information
I have seen in that. If two indications present in weld, the max permissible size is 4mm. It is correct or not.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

mechengineer
  • Question
Studding Flange Design as per Code
Replies
1
Views
3K
r6155
r6155
FAHADRANA
  • Locked
  • Question
WQT for Combination of Welders as per ASME Sec IX
Replies
3
Views
4K
DekDee
DekDee
YuJie_PV
  • Question
Membrane or Membrane+Bending when assessing local failure protection per ASME VIII-2
Replies
8
Views
6K
YuJie_PV
YuJie_PV
mrpsi
  • Locked
  • Question
Qualifying A4-70 bolt per ASME B31.3
Replies
2
Views
707
mrpsi
mrpsi
foxtrot_67
  • Locked
  • Question
Half Pipe style Shell-to-Shell Calcs per ASME VIII.1
Replies
3
Views
320
XL83NL
XL83NL

Part and Inventory Search

Sponsor

Back
Top Bottom