Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Please explain, As per ASM sec.VII

Status
Not open for further replies.
RVinothkumar

RVinothkumar

Mechanical
Joined
Apr 16, 2021
Messages
31
Location
IN
Please explain,
As per ASM sec.VIII Dev.1 if two indication found in RT Film of weld joint what is the acceptance criteria for that
 
Sort by date Sort by votes
Ok sir, Thanks for your information
I have seen in that. If two indications present in weld, the max permissible size is 4mm. It is correct or not.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

mechengineer
  • Question Question
Studding Flange Design as per Code
Replies
1
Views
3K
r6155
r6155
FAHADRANA
  • Locked
  • Question Question
WQT for Combination of Welders as per ASME Sec IX
Replies
3
Views
4K
DekDee
DekDee
YuJie_PV
  • Locked
  • Question Question
Membrane or Membrane+Bending when assessing local failure protection per ASME VIII-2
Replies
8
Views
7K
YuJie_PV
YuJie_PV
mrpsi
  • Locked
  • Question Question
Qualifying A4-70 bolt per ASME B31.3
Replies
2
Views
1K
mrpsi
mrpsi
foxtrot_67
  • Locked
  • Question Question
Half Pipe style Shell-to-Shell Calcs per ASME VIII.1
Replies
3
Views
440
XL83NL
XL83NL

Part and Inventory Search

Sponsor

Back
Top