Has anyone used Cubloc Studio? How do i set an output?
Has anyone used Cubloc Studio? How do i set an output?
(OP)
We purchased a CUSB-14R with a Cubloc CB280 Cpu, I downloaded the studio and I can set up an input with no issues in the ladder, but there is no operators for setting up an output or a delay for that matter. was going to use it to automate a door interlock so that the operator wouldn't have to hit several switches after door was closed.
Called their Tech support, they told me to email them. they do not offer phone support apparently and I sent that email 6 hours ago.
I have used Click and Direct Logic PLC's and I should have stayed with them.
Thanks
Called their Tech support, they told me to email them. they do not offer phone support apparently and I sent that email 6 hours ago.
I have used Click and Direct Logic PLC's and I should have stayed with them.
Thanks
"I am stuck on Band-Aid brand, 'cause they are stuck on me"
RE: Has anyone used Cubloc Studio? How do i set an output?
Edit - that's not a very active forum. I wonder what happened. Is Cubloc selling?
RE: Has anyone used Cubloc Studio? How do i set an output?
Copy/paste from there:
Const Device = CB280 ' Select device
UsePin 0,In,START ' Declare pins to use
UsePin 1,Out,RELAY
Alias M0 = MOTORSTATE ' Set Aliases
Alias M1 = RELAY1STATE
Set Ladder On ' Start Ladder.
Then check the section on ladder logic under: http://comfilewiki.co.kr/en/doku.php?id=cubloc:ind...