Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Reciprocating Compressor

Status
Not open for further replies.
marchieV

marchieV

Mechanical
Mar 18, 2016
71
Hello.

Can I use the Modal Analysis Type under Dynamic Analysis in checking the natural frequency of piping requirements of 4Hz connected in a reciprocating compressor?

Thank you.

Regards,

March
 
Replies continue below

Recommended for you

Sort by date Sort by votes
You can use RPM/60 Hz +/-20% to avoid possible resonance with pressure pulsation of recip compressor.
 
Upvote 0 Downvote
You can. But 4 hz is the question. Did you check API 618 how to do and what to do? What is the compressor shaft RPM?Is this a small compressor or large gas compressor? Do you use pulsation reduction bottle and orifices?
I guess you need to get compressor manufacture’s advice on the issue.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

jozm
  • Locked
  • Question
piping stress analysis for centrifugal compressor
Replies
2
Views
233
MJCronin
MJCronin

Part and Inventory Search

Sponsor

Back
Top Bottom