Your product license has numerical problem size limits
Your product license has numerical problem size limits
(OP)
Hi,
I keep getting this error about my problem essentially being too complex for the student software to allow it to be solved. I have a support which contains a tube in which I applied 3 forces and a moment. Even when I use The mesh size it doesn"t run and it keeps showing me same error. any suggestions please ?
I keep getting this error about my problem essentially being too complex for the student software to allow it to be solved. I have a support which contains a tube in which I applied 3 forces and a moment. Even when I use The mesh size it doesn"t run and it keeps showing me same error. any suggestions please ?
RE: Your product license has numerical problem size limits
student's version of ANSYS is limited. For structural analysis is it 32k nodes/elements and 50 bodies or 300 surfaces.
Best regards
JK