Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ansys - modelling oblique bearing with joint, remote point

Status
Not open for further replies.

framat

Mechanical
Joined
May 7, 2018
Messages
5
Location
IT
Hy,
I would like to perform an analysis of a power trasmission where are used oblique bearing. So, I'm asking myself if there is a way to model the oblique bearing with a joint or remote poin in order to have the correct direction of the force.
Thanks
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top