How to design a gas engine unit with a whole P&ID description?
How to design a gas engine unit with a whole P&ID description?
(OP)
Hello,
Data I am provided with is as follows: a Gas engine with 2MW electric power and 48.5% efficiency powered by biogas during combustion of fuel with excess air equal to 2.2 emits 700 mg / m3 of nitrogen oxides. The exhaust gas temperature after the engine is 430oC. To reduce nitrogen oxides, a reduction chamber (RC) was installed behind the engine, in which the SNCR process will take place. Design a system for supplying gas burner installed in the RC (fuel biogas) if the engine is operating in an explosion hazard zone 1. Propose the solutions for use the energy of exhaust gas from the RC chamber to reduce the costs of reducing nitrogen oxide emissions. Prepare a technical and economic analysis for selected variants, including environmental impact.
I will be very grateful for any kind of advice on how to approach this project.
Data I am provided with is as follows: a Gas engine with 2MW electric power and 48.5% efficiency powered by biogas during combustion of fuel with excess air equal to 2.2 emits 700 mg / m3 of nitrogen oxides. The exhaust gas temperature after the engine is 430oC. To reduce nitrogen oxides, a reduction chamber (RC) was installed behind the engine, in which the SNCR process will take place. Design a system for supplying gas burner installed in the RC (fuel biogas) if the engine is operating in an explosion hazard zone 1. Propose the solutions for use the energy of exhaust gas from the RC chamber to reduce the costs of reducing nitrogen oxide emissions. Prepare a technical and economic analysis for selected variants, including environmental impact.
I will be very grateful for any kind of advice on how to approach this project.
RE: How to design a gas engine unit with a whole P&ID description?
TTFN (ta ta for now)
I can do absolutely anything. I'm an expert! https://www.youtube.com/watch?v=BKorP55Aqvg
FAQ731-376: Eng-Tips.com Forum Policies forum1529: Translation Assistance for Engineers Entire Forum list http://www.eng-tips.com/forumlist.cfm
RE: How to design a gas engine unit with a whole P&ID description?
RE: How to design a gas engine unit with a whole P&ID description?
Remember - More details = better answers
Also: If you get a response it's polite to respond to it.