Showkat Ahmad
Civil/Environmental
IS there any way to know if the areas are glued together and whether the mesh attributes are attributed to different areas.
Thank you
Thank you
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
how to know if the areas are glued together for an I section in APDL 1
- Thread starter Showkat Ahmad
- Start date
- Status
-
1
- #2
Erik Panos Kostson
Structural
You can probably see this if they share a common line (list all areas and look on their line definition). Easiest is just run a modal analysis and that will show you if they are connected (as FEAway mentioned)
Erik Panos Kostson
Structural
If I remember (have not done a lot of geom. lately in APDL - been some years ago), one can use the partition command to partition APTN, and thus connect things.
- Status
Similar threads
- Question
- Locked
- Question
- Question
- Locked