Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

dross on mild steel

Status
Not open for further replies.

horizon shop

Industrial
Joined
May 14, 2018
Messages
1
Location
CA
Any advice on how to get rid of dross on 0.045" - 0.074" mild steel when cutting with nitrogen?
 
You may want to post this in Structural Engineering, Welding, or Metal and Metallurgy.

Dik
 
Try the ACAD command "OVERKILL" to remove and consolidate extraneous line segments. [wink]

STF
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top