Hi this is my first post so bear with me. My current employer purchased a used 2008 Amada2415 about 1.5 years ago and its been quite a learning experience for me. We also have the LMP-3015 sheet loader. My question is in regards to cutting conditions on .120 1018 MS. I have cut this material with great results for quite some time and all of the sudden it just wont cut satisfactory. The cut leave small but noticeable dross on the back side. I have tried all i know from focus adjustment, new nozzle, cleaned and changed lens, tried conditions with both 5 and 7.5 lens to no avail. Thanks for any help, Jason.
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
Manufacturers are at a critical juncture. Either they evolve their product processes or get disrupted by new competitors who have been built from the ground up to develop complex systems and products defined by software. Download Now
Savvy engineers have eagerly anticipated the impact of virtual reality (VR) on robot programming technology, as it can dramatically increase productivity by empowering engineers to do their jobs safer and more efficiently. Download Now