I have a bit of confusion regarding the rules stated in the AS/NZS 1170 Section 5 on determining the internal pressure coefficient. I am wondering, is the Cpi determined from the table 5.1(A) or 5.1(B) for the whole building? Or is it only used as the Cpi on one surface?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Internal Pressure Coefficient (AS/NZS 1170)
- Thread starter Xaviera
- Start date
rowingengineer
Structural
Awner is read design of portal frame building by scott woolcock
"Programming today is a race between software engineers striving to build bigger and better idiot-proof programs, and the Universe trying to produce bigger and better idiots. So far, the Universe is winning."
"Programming today is a race between software engineers striving to build bigger and better idiot-proof programs, and the Universe trying to produce bigger and better idiots. So far, the Universe is winning."
- Status
Similar threads
- Question
- Locked
- Question
