Cutting head connection while machine hovers after edge detection??

I would replace the plug on the cone that the sensor wire plugs into that is the problem we have. The sensor wire will jiggle as the head travels and once the wire brakes connection you will get that alarm. Check and see if the small pin in the plug broke off and is stuck inside the sensor wire because if it did you will need to replace both. Now if the head while moving down toward the material just stops and starts moving up your cone is bad.

Right on i will check it as soon as the current run is finished. It is running ok if i leave the traverse speed at 50%.

That seems to have worked. Thanks yet again LaserDog!!!