Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
amada lc-1212cxII
- Thread starter robtoby
- Start date
JayMaechtlen
Industrial
A real good starting point would be to use the cutting conditions built into the machine control.
If the machine was sold new in the same country/region you're in, then Amada or the selling distributor should offer some applications support.
What laser generator does your unit have?
What kind of cutting? Large contours, or small holds and delicate contours?
Regards
Jay
Jay Maechtlen
If the machine was sold new in the same country/region you're in, then Amada or the selling distributor should offer some applications support.
What laser generator does your unit have?
What kind of cutting? Large contours, or small holds and delicate contours?
Regards
Jay
Jay Maechtlen
- Status
Similar threads
- Locked
- Question