Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

partitioning 3d model of a quarter circle

Status
Not open for further replies.

gomavs123

Mechanical
Joined
Aug 8, 2013
Messages
1
Location
US
Hello, what I have right now is to partition a 3-d small quarter cylinder. I have done a section sketch at the surface of the quarter circle and partitioned that, but I don't know how to extend this surface sketch through the material (via z direction in the picture). Although the circle figure looks like a collection of lines in the picture, it is a circle sketch. Any help on doing this will be appreciated!

9l7.png
 
Have you tried Partition->Cell->Extrude/Sweep Edges?

Han primo incensus
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top