MysteriousDrX
Aerospace
Is it possible to change the size of the print margins in DraftSight?
I need them the be an even 0mm or 5mm on all four sides, however I can find no way to physically changes them.
Or at least if I could find out what the existing margins are then I could adjust my border template accordingly.
Surely it must be possible to do one of these things!?
I need them the be an even 0mm or 5mm on all four sides, however I can find no way to physically changes them.
Or at least if I could find out what the existing margins are then I could adjust my border template accordingly.
Surely it must be possible to do one of these things!?