SimulationXpress Study: Failed

Question

SimulationXpress Study: Failed

battlehands (Electrical)

(OP)

12 Apr 11 18:08

I have attempted to run a stress analysis on a few very simple part that I`ve created. Each attempt results in the same error message, "Part-1 SimulationXpress Study: Failed".

The following screenshot shows one of the parts with the error received upon running the simulation. Please advise.

http://imagebin.org/147851

kellnerp (Mechanical) · Answer 1 · 2011-04-20 19:49:07

Do you think you could rotate your image to show all the boundary conditions?

TOP
CSWP, BSSE
www.engtran.com www.niswug.org
www.linkedin.com/in/engineeringtransport

"Node news is good news."

corus (Mechanical) · Answer 2 · 2011-04-21 16:20:08

It looks like you only have one restraint normal to a face. You need to stop rigid body motion with additional restraints.

Tara

http://tinyurl.com/4ydjg7m

kellnerp (Mechanical) · Answer 3 · 2011-04-21 19:09:43

Can't be sure until he shows us the rest of the face with restraints on it. The feature tree says Fixed.

TOP
CSWP, BSSE
www.engtran.com www.niswug.org
www.linkedin.com/in/engineeringtransport

"Node news is good news."

Come Join Us!

Posting Guidelines

SimulationXpress Study: Failed