How does one model a beam that has the bottom half of the beam coped out of the middle third of the span? I have tried using three segments (end spans as a W-Shape, middle span as a WT-shape) with the ends fixed, but get Error code 2049 (Framing problem, beam is unsupported).
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Model a beam that is coped at mid-span
- Thread starter gb156
- Start date
JoshPlumSE
Structural
You cannot create this type of beam in RISAFloor. I cannot think of a good work around other than to model the beam in RISA-3D instead.
- Status
Similar threads
- Locked
- Question
