Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Jacket design in COMPRESS

Status
Not open for further replies.
treemkr

treemkr

Mechanical
Oct 3, 2006
18
How have users handled jacket design in COMPRESS? Alternately, does COMPRESS have plans to include this capability in future release(s)?

I suppose I could model independently as a vessel, but how would you handle a concave closure at the top?

Any suggestions would be appreciated
 
Replies continue below

Recommended for you

Sort by date Sort by votes
The only way to do it is to set up a separate model. Closure bars have to be handled indepently of Compress.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Amr Shams
  • Locked
  • Question
Assistance for Multi-Chamber Vessel Design in COMPRESS
Replies
2
Views
3K
amillsmuel
A
withak36301
  • Locked
  • Question
Seismic Calculations in Compress Without Supports 1
Replies
2
Views
884
withak36301
withak36301
Amr Shams
  • Question
Advisory Warning on CS-2 Vacuum Chart Temperature Limit- Allowable compressive stress
Replies
0
Views
2K
Amr Shams
Amr Shams
AK8824
  • Locked
  • Question
Seismic Design of Columns using NBC 2015
Replies
0
Views
603
AK8824
AK8824
uglyspec
  • Locked
  • Question
Compress FEA Module
Replies
3
Views
988
Sue23
Sue23

Part and Inventory Search

Sponsor

Back
Top Bottom