Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

treatment of 0-1 tool steel

Status
Not open for further replies.
brents

brents

Industrial
Joined
Dec 15, 2004
Messages
34
Location
US
I have a print from japan that I am making parts for right now..

it is made from 0-1 tool steel

It calls out for heat treat to 59-63 Rc..no problem, but it also calls out for a surface treatment MICr2..

I have been all over the internet and I can't figure out what MICr2 is..

Any help would be greatly appreciated.

thanks,
Brent
 
Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

J
  • Locked
Need to paint carbon steel wire with fluorescent coating, either enamel, acrylic or other. What would be the best primer to use?
Replies
0
Views
774
Jon Davidson
J
zaim1996
  • Locked
  • Question Question
How to calculate the equilibrium of dilution tank ?
Replies
1
Views
728
bimr
bimr
Alex07
  • Locked
  • Question Question
Opinion of geomembranes?
Replies
2
Views
627
bimr
bimr
Mechanical_weld
  • Locked
  • Question Question
1.4404 resistant
Replies
4
Views
639
Mechanical_weld
Mechanical_weld
dreamstar12
  • Locked
  • Question Question
How to monitor and control partial pressure of water vapor in nitrogen gas?
Replies
0
Views
457
dreamstar12
dreamstar12

Part and Inventory Search

Sponsor

Back
Top