Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
NX DRAFTING 2
- Thread starter EngMfg1
- Start date
-
1
- #2
-
1
- #3
That will work for the session, but I believe to permanently turn it off, you need to edit your ug_metric.def or ug_english.def file & set the customer default for UG_showDrawingGrid to off.
Tim Flater
Senior Designer
Enkei America, Inc.
Tim Flater
Senior Designer
Enkei America, Inc.
cowski,
File is what I meant by session. Sorry for the confusion & thank you for the clarification.
Tim Flater
Senior Designer
Enkei America, Inc.
File is what I meant by session. Sorry for the confusion & thank you for the clarification.
Tim Flater
Senior Designer
Enkei America, Inc.
Tim, I'm the one that should apologize. I was thinking of my definition of session (shut it down for the day - go home, today's session is over) rather than UG's definition of session.
I am glad that you mentioned the .def files, I rarely do any editing on them so I often forget to mention them (but since our admin quit recently I'll probably have plenty of opportunity to learn about them!).
I am glad that you mentioned the .def files, I rarely do any editing on them so I often forget to mention them (but since our admin quit recently I'll probably have plenty of opportunity to learn about them!).
cowski,
If you need some general help with the .def files, let me know. I can help you out with gateway, modeling or drafting...maybe some with assemblies. I've got plenty of experience turning off & on those things that GM sets as defaults when using their toolkit.
I can't post my contact information here, but if you need it, look on bbsnotes or post there.
Tim Flater
Senior Designer
Enkei America, Inc.
If you need some general help with the .def files, let me know. I can help you out with gateway, modeling or drafting...maybe some with assemblies. I've got plenty of experience turning off & on those things that GM sets as defaults when using their toolkit.
I can't post my contact information here, but if you need it, look on bbsnotes or post there.
Tim Flater
Senior Designer
Enkei America, Inc.
- Status
