Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Sizing a Blower for Fume Collection

Status
Not open for further replies.

dhoxworth

Mechanical
Joined
Aug 21, 2003
Messages
18
Location
US
I'm trying to size a blower for a fume collection application. What I need is a reasonable assumption/guess for entrance velocity (CFM) for such an application. Any ideas? Thanks in advance.
 
Oh yeah...we don't anticipate there being much fumes. I don't even know a good estimate on what we expect. I just want a reasonable sized blower that can get rid of a very small amount of fumes. We have a 4-inch line into the HVAC.
 
try putting this in the hvac section

Also we need a bit more info

what fumes are they?

whats the process?

Could a small hood be put over the source of contamination?

Is the processs in a large room or a small room etc



Friar Tuck of Sherwood
 
try putting this in the hvac section
yeah, i was thinking about that, but didn't think it was necessarily an HVAC item.

what fumes are they?
UF6

whats the process?
potential for UF6 escape when making connections. we don't anticipate a whole lot of vapors.

Could a small hood be put over the source of contamination?
no

Is the processs in a large room or a small room etc
large room
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top