prostocktom
Mechanical
ANY ONE OUT THERE MACHINING THIS ALLOY. LOOKING AT MAKING SOME PARTS FROM IT. WAS WONDERING ABOUT IT.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
ZK60-T5 MAGNESIUM
- Thread starter prostocktom
- Start date
- Status
I am not actively involved in machining Mg, but I recommend reviewing the following brochure from Hydro Magnesium on the subject:
- Status
Similar threads
- Locked
- Question
- Locked
- Question