Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

zero thickness geometry ?

  • Thread starter Thread starter Navarone
  • Start date Start date
N

Navarone

Guest
I am getting a "zero thickness geometry" error but I don't know what causing it. I have two profile sketches and 4 guide curves.


--- I tried uploading an image only 13k but this site won't load it. Anyway. I thought I could show you. What a bummer!
smiley11.gif

Edited by: Navarone
 
Ok, I figured out what was wrong. I was using some 3d sketch curves for my profiles, top and bottom. I didn't realize that you had to make them surfaces inorder to complete the loft. That's what I did and it worked out perfectly.
 

Part and Inventory Search

Sponsor

Back
Top