Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

z direction(out of plane) material properties for composites

Thread starter alleak
Start date Oct 7, 2005

Status: Not open for further replies.

Oct 7, 2005

alleak

Mechanical

Hi;
I am analysing a 3D composite pressure vessel with ansys.I use shell 99 elements and want to know max. tsai-wu failure criterian.for material properties i have seen composite handbooks and there is only properties in directon 1,2 and 1-2 but there is not anything mentioned for direction 3.It is necesary for ansys to enter at least Ez and Ztenstrs which are indirection 3, otherwise it can not solve the problem.what should i do.is ut correct to enter properties in direction 2(in-plane off-axis) for directon 3(out of plane).can i put other 3 direction properties blank.is it correct.any help would be appreciated.

Cheers

alleak