I am currently working on calculations for a wire wound cylinder following Young's and Brownell's approach. However, I've noticed that there are no specific calculations available for a wire wound yoke frame design. Additionally, even the ASME Section VIII Division III only provides stress formulas for wire wound cylinders. I was wondering if anyone here could kindly share a case study or information related to the design of a wire wound yoke frame. Any assistance would be greatly appreciated
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Yoke Frame of Wire wound Vessel
- Thread starter Umar107
- Start date
Similar threads
- Locked
- Question
- Locked
- Question