Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Yield Strength
- Thread starter MARKH1958
- Start date
EdStainless
Materials
Pull a tensile test.
How was it heat treated? (actually, what is the thermo-mechanical history) without knowing that you don't have a chance.
= = = = = = = = = = = = = = = = = = = =
P.E. Metallurgy, Plymouth Tube
How was it heat treated? (actually, what is the thermo-mechanical history) without knowing that you don't have a chance.
= = = = = = = = = = = = = = = = = = = =
P.E. Metallurgy, Plymouth Tube
Just to take a wild stab at it, I'd guess somewhere between 80,000-100,000 PSI. Maybe as high as 115,000, particularly at the higher end of the hardness range. I'll assume quenched and tempered. A lot will depend on section size and tempering temperature.
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question
