altoid3000
Mechanical
I am trying to read y axis value in Fig 4A in WRC 107. The numbers dont make any sense. What is the value for beta = 0.04, gamma = 84.5?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
WRC 107 figure 4A
- Thread starter altoid3000
- Start date
- Status
I don't have a copy of the thing. One thing that I remember being confusing in the past, though, was that things are plotted on logarithmic scales, even though they change signs. Since a logarithmic scale never reaches zero, that leaves a gap in the chart at that point.
My reading is close to 3.5.
Numbers on vertical scale are from .001 to 100: quite difficult to read indeed, this is only my interpretation.
prex
Online tools for structural design
Numbers on vertical scale are from .001 to 100: quite difficult to read indeed, this is only my interpretation.
prex
Online tools for structural design
- Status
Similar threads
- Locked
- Question
- Locked
- Question