Working Threads?

[gotmud]

Let's say I have a vice (the actual assemble is a little bit different, but it works the same way). I want to be able to simulate the motion that when I trun the handle that the vice jaw will close/open. Is there a way to assemble the components that when I rotate the handle, it will do this.

 

[SBaugh]

http://www.scottjbaugh.com/Design_Portfolio/Contributed_Files/Helical_Mate.zip

Regards,

Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376
faq559-716 - SW Fora Users

 

[MadMango]

You could also look into using the Simulation Toolbar.

[green]"I think there is a world market for maybe five computers."[/green]
Thomas Watson, chairman of IBM, 1943.
Have you read faq731-376 to make the best use of Eng-Tips Forums?