Let's say I have a vice (the actual assemble is a little bit different, but it works the same way). I want to be able to simulate the motion that when I trun the handle that the vice jaw will close/open. Is there a way to assemble the components that when I rotate the handle, it will do this.
Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Working Threads?
- Thread starter gotmud
- Start date
Regards,
Scott Baugh, CSWP
![[pc2]](/data/assets/smilies/pc2.gif "[pc2] [pc2]")
3DVision Technologies
faq731-376
faq559-716 - SW Fora Users
- Status
Similar threads
- Locked
- Question