I just downloaded this physical dynamics demonstration for ACAD Inventor:
(10MB .avi file)
In it are great working examples of various dynamics, including a pulley/belt setup. I'm jealous. This has been discussed on this board before, and I have yet to find a solution in SW05. I primarily use SW CAD to design and build things that incorporate assemblies that interract with each other. I realize I could just add a rotary simulation to the other pulley and get the same results, but that is not the point. I want one pulley to drive the belt that drives the other pulley that drives...you know. Who says I fixate on minutiae?
Anyone can be Captain in a calm sea.
(10MB .avi file)
In it are great working examples of various dynamics, including a pulley/belt setup. I'm jealous. This has been discussed on this board before, and I have yet to find a solution in SW05. I primarily use SW CAD to design and build things that incorporate assemblies that interract with each other. I realize I could just add a rotary simulation to the other pulley and get the same results, but that is not the point. I want one pulley to drive the belt that drives the other pulley that drives...you know. Who says I fixate on minutiae?
Anyone can be Captain in a calm sea.