Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Workbench crashes when trying to hide/unhide components

Status
Not open for further replies.
cbrn

cbrn

Mechanical
Joined
Jun 28, 2005
Messages
1,066
Location
IT
Hi,

does anybody know the reason why Workbench 9.0 crashes when trying to hide / unhide components in an existing assembly?

Is there a known solution or do you think I'd better try and re-install Workbench?

Thanks in advance,
regards
 
Status
Not open for further replies.

Similar threads

W
  • Question Question
Trying to couple a transient thermal and structural simulation but I get zero deformation and stress
Replies
0
Views
2K
weldtest12
W
H
  • Locked
  • Question Question
how to apply triangular load on an area, in ANSYS Workbench static module
Replies
1
Views
3K
karachun
karachun
IJR
  • Locked
  • Question Question
On how and where to insert command snippets inside Workbench mechanical
Replies
2
Views
1K
IJR
IJR
TeoAlfa
  • Locked
  • Question Question
ANSYS Mechanical - Concrete embedded steel components
Replies
0
Views
737
TeoAlfa
TeoAlfa
struclearner
  • Locked
  • Question Question
Reaction Force Distribution in ANSYS Workbench!
Replies
0
Views
1K
struclearner
struclearner

Part and Inventory Search

Sponsor

Back
Top