Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Wood-Structure
- Thread starter CTruax
- Start date
- Thread starter
- #3
There are some good sites for routines to add from. i.e.
But you would have to get get more detailed in what you want exactly.
"Whether you think that you can, or that you can't, you are usually right "
.. Henry Ford
But you would have to get get more detailed in what you want exactly.
"Whether you think that you can, or that you can't, you are usually right "
.. Henry Ford
- Thread starter
- #5
Detailed:
I would like to take the design results of my VB6 footing design (say 31"sq X 18"deep with 4-#4 bars each way supporting 4x6x8' post in a Simpson CBSQ46 ) and transfer that information to ACADr14 which would prompt for the centerpoint and then draw the pad, rebar, post, & base in 3D on 4 different layers: Conc, Hardware, Wood, Rebar
I would like to take the design results of my VB6 footing design (say 31"sq X 18"deep with 4-#4 bars each way supporting 4x6x8' post in a Simpson CBSQ46 ) and transfer that information to ACADr14 which would prompt for the centerpoint and then draw the pad, rebar, post, & base in 3D on 4 different layers: Conc, Hardware, Wood, Rebar
- Status
Similar threads
