Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations Danlap on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Wireless "wire" 1

Status
Not open for further replies.

AJustice

Mechanical
Jul 9, 2010
12
Hi, I was wondering if anyone had a "low cost" solution in creating a system to read a 0-5V AC signal and wirelessly transmit then "reproduce" the signal. I need "high" accuracy, say +- 0.5%
 
Replies continue below

Recommended for you

Define "system"
Semiconductor level?
Module level?
Boxed Solution level?

Define "low cost"

There are solutions for all, but your question begs for clarification.

Benta.
 
Basically, I want a set of ICs that I could provide power and an AC signal to and "replace" a length of wire. They would only "talk" to each other, allowing for multiple sets of ICs in the same area. The semiconductor level is prefered(cost), I have found some "boxed" sets for $150+, but I am looking for more of a $5-$20 range.
 
PIC with a 10-bit A/D (better to find one with a 12-bit an throw away some bits after preprocessing) and a Bluetooth module. Cost you about $10 in materials and some programming time.

Done.


Dan - Owner
Footwell%20Animation%20Tiny.gif
 
Dan you're a bit optimistic on the BT module. More like 20$ if you want one with stack (and you do, due to regulatory issues).

Benta.
 
what is "stack"? I am looking at the TI msp430rf-2500. I just don't know how "good" of a signal I would get from that circuitry. They say it has a 10bit ADC and up to 200kBps data rate. How do you get a "feel" for how accurate the sampling/ADC/DAC would be?
 
Re "stack"

There are basically two types of Bluetooth (BT) modules:

HCI or "host controller interface". This is a very basic and cheap module that requires that you put most of the BT protocol stack firm/software) in your host controller. Only viable if you are planning to produce 50k+ units due to excessive cost of test equipment and certification (FCC, R&TTE etc.).

Port Replacement Module. This additionally features an onboard controller containing the full BT stack. You interface to the module via a CMOS UART using AT-commands (Hayes), just like a modem. No certification issues, these modules can be used out of the box as they are already certified. I would go this way in your place.
Example here:
Benta.
 
Hi Guys,
I would be interested in this too, but I am after a 4-20ma bluetooth system. Basicly I need to get a current loop signal 30m (100ft) to a small LCD display box. Do you think you could kill two birds with one stone and help us both out?

Thanks in advance.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor