Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Wildfire "blinks out" if I try to use mechanica on a part

  • Thread starter Thread starter Nose Bleed
  • Start date Start date
Status
Not open for further replies.
N

Nose Bleed

Guest
Yup - wildfire had a bug in it that caused your model to go into wire frame mode, or sometimes the model would disappear intirely - you would have to sometimes completely close down WF, then restart it.



The latest maintenance update for WF has fixed this bug... which was updated like two weeks ago...
 
Status
Not open for further replies.

Similar threads

BryanAyers
  • Locked
  • Question Question
Creo 9 drawing's tables, "part perimeter", how to setup?
Replies
0
Views
855
BryanAyers
BryanAyers
jasongBSME
  • Locked
  • Question Question
Converting from Pro/Mechanica to Creo Simulate
Replies
0
Views
805
jasongBSME
jasongBSME
T
Pro mechanica - create a mesh from imported points (nodes)
Replies
1
Views
24K
Twig Studio
T
LaBishop
  • Locked
  • Question Question
I am wanting to create a hexagonal beam.
Replies
1
Views
801
looslib
looslib
DKrol
  • Locked
  • Question Question
Export STEP file from Creo to Solidworks
Replies
1
Views
815
goeasyon
goeasyon

Part and Inventory Search

Sponsor

Back
Top