Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Wildfire 2 & Interchanges

Thread starter cgluyas
Start date Jan 19, 2005

Status: Not open for further replies.

Jan 19, 2005

cgluyas

Mechanical

Has anybody else had major problems with Wildfire 2 and interchanges? It just does not seem to see the parts within them, yet if you open the replacement part into session it does and everything works fine.
Can anybody shed some light. Currently running cut 080.
Thanks

Craig